Ultima derma pen E30
Derma Pen Introduction
Minimised epidermal damage
Less pain and erythema as high speed with vertical direction
More easy to operate at the small or curved areas
Adjust micro needle length (0.25~2.5mm)
Prevent cross infection, adopt with disposable needles
More quickly and efficient than manual Micro-needle
1. Atomatic and charging
2. Adjustable Needle length from 0.25mm to 2.5mm
3. Adjustable 5 level speed control to 15000rpm
4. 1/3/5/7/9/12/24/36/42/Nano/3D Nano/5D Nano needles Tip using 30 gauge Acupuncture Needles to reduce discomfort
5. Digital Motor in Hand-piece
6. Highest quality for medical professionals(Aluminum Housing)
7. Optimal absorption of products
8. Compact and ergonomic design
|Power supply||charging or battery|
|Needle material||nano wafer /imported medical stainless steel|
|Needle number||1/3/5/7/9/12/24/36/42/Nano/3D Nano/5D Nano needles|
|Body material||Aluminum Alloy Shell|
|Body color||Golden Rose|
Derma Roller is used for one of the following skin problem:
1.scar removal- including acne scar removal/ treatment
2.stretch mark removal / treatment
3.anti-aging, anti wrinkle
4.cellulite reduction or removal
5.hair loss treatment
6. hyper pigmentation treatment
A. Visual and noticeable improvement in a few days from the first treatment.
B. Short healing time.
C. No permanent damage or injury.
D. No bruising, infection, discoloration or other complications.
E. Extremely high absorption of any active ingredients.
F. Almost all skin types can be treated.
G. thickens the dermis without damaging or removing epidermis.
How to Operate
(1) Plug in DC adapter to the jack.
(2) Plug in DC adapter to AC outlet.
(1) Take out needle cartridge in the sterilized packing.
(2) Fitting round slots 1 into 2 of machine, push needles cartridge horizontally up to the end .
(3) Lock the cartridge by turning it to the counter clockwise.
(4) Adjustment of needles length should be done after turn on the machine.
(5)If you want to remove the needle cartridge, turn it to the clockwise and push out horizontally, fitting round slots(slot 1,slot2)together.
3. Adjustment of speed and needle length
(1) Adjustment of Speed and ON/OFF
(2) 5 speed level control
Pressing the switch 2 seconds to open the device, It starts from the lowest speed to highest speed when you turn on the power firstly.
The speed cycles low to high. Please press the switch 2 seconds when you need to stop the device.The flicker’ s frequency of light faster, the speed is higher.
(3) Adjustment of needles length
You can adjust the length of needle by turning the adjustment ring clockwise or counter clockwise. Turning it clockwise, length of it will be longer.